User’s Manual—SNAP™ 700 Printer 61
Classification: Avery Dennison - Public
contains an anti-static wrist strap and gloves.
a. If your company has not purchased the spare parts kit, buy the anti-
static wrist strap at your local electronics store.
b. Extra anti-static gloves can be ordered from AVERY DENNISON.
c. If an anti-static glove is not available, thoroughly wash and dry your
hands before handling the print head.
3. Do not touch any terminals extending from the print head or the print line.
CAUTION: Never remove the print head from the printer
except to replace it.
Optimal benefits are received when you follow AVERY DENNISON’s cleaning
supply recommendations.
1. Always use clean supplies.
2. Use alcohol and the loop side of a Velcro pad or a cotton pad to clean
the print head.
3. Never use anything abrasive to the print head.
4. Never use anything metallic on or near the print head.
6.1.2 Cleaning Procedures
CAUTION: AVERY DENNISON recommends Master
Cleaning Kit #921341K for use in cleaning print heads.
1. Before cleaning any part of your SNAP 700 printer, turn off the power to
the printer.To avoid damaging the print head, wear the anti-static wrist
strap (which must be in contact with the skin and be tight). Be sure the
button on the strap comes into direct contact with your skin.
2. Fasten the clip end of the anti-static wrist strap to a metal portion of the
printer (usually the stacker) to prevent static from your skin from entering
the print station.
3. Wear anti-static gloves at all times when handling a print head to prevent
oils from your hands from contaminating the print head. While wearing
the gloves, remove the cotton or Velcro pad from the package.
4. After 2 to 4 hours of continuous use: Apply a liberal amount of alcohol to
a cotton pad and rub firmly across the print line of the print head several
times to remove any build-up of ink, dust, dirt or debris. Wait a few
minutes for the alcohol to evaporate, and resume printing.
5. After 8 hours of use: Apply a liberal amount of alcohol to the loop side of
a Velcro pad and rub firmly across the print line of the print head several
times to remove any build-up of ink, dust, dirt or debris. Wait a few
To Next Page
Loading...
