1640-IN-031-C-08
Page 14 of 104
Eurotherm/Barber-Colman
MACO Series Controller Installation
Figure 1.6C 16 Slot Controller Board Locations (6 Slots of I/O)
Optional:
Slot #16
Slot #15
Slot #14
Slot #13
Slot #12
Slot #11
Power Supply
Slot #9
Slot #1
Slot #2
Slot #3
Slot #4
Sequence/Hydraulics
Slot #6
Slot #7
Data Handler
Mother Board
See Wiring
Detail Below
Analog I/O Bd #1 in Slot #3.
2nd Seq Bd in Slot #6.
Start in Slot #2 with remaining Temperature
Bds (5 max.), followed by Comm Bd.,
followed by all Parison Bds (2 max.).
Output Bd #1
Output Bd #2
Output Bd #3
Output Bd #4
Input Bd #2
Input Bd #1
Slot #2, 3,
4, 6, 7 & 9:
Slot #11:
Slot #12:
Slot #13:
Slot #14:
Slot #15:
Slot #16:
Standard:
Slot #1:
Slot #5:
Slot #8:
Slot #10:
Temperature (T/C-Analog) Bd #1
Sequence/Hydraulics Bd
Data Handler Bd
Power Supply Bd
Note: When counting boards in multi-rack
systems (for switch settings, RLD/screen pro-
gramming) count each control rack separately.
Energize CR 606
and
Energize CR 607
(if Hi Density I/O)
Note: Analog output boards (if used) follow the
last digital output board.
CAUTION:
Controller MUST be operated with Cover in place! Wires and Boards carry High
Voltage which may cause Severe Shock or Electrocution. When inserting or
removing Boards, make certain ALL power is OFF. When removing boards, use
card pullers at top and bottom of board. Pull board out approximately 1" and use
insulated screwdriver to "pop" connector free.
B.1
Earth (Safety Ground)
No Connection
L2 Vac IN
No Connection
L1 Vac IN
Top
E24-1261
Viewed from side
of Controller
E24-1134-005
IMPORTANT:
EMC Critical Item
To Next Page
Loading...
Need help?
General
