Barber-Colman MACO Series - Figure 11.3 Wiring the Analog Output Board

1640-IN-031-C-08
Page 76 of 104
Eurotherm/Barber-Colman
MACO Series Controller Installation
Figure 11.3 Wiring the Analog Output Board
DC+
DC-
Earth (no connection)
24 Vdc
Supply
+
-
Bond to
Chassis
Bond to
Chassis
Out 1 +
Out 1 -
Out 2 +
Out 2 -
Out ...
Power Supply outputs MUST have
ferrite beads capable of filtering
30 MHZ to 100 MHZ
(Braided Shield)
(Overbraid)
Ground at BOTH Ends!
(Installed at Factory)