SECURUS
Configuration
Delivery
Cartridge no.
State
061686
logged off
SECCANT
on CAN-Bus
logged off
logged offState
Lubrication
Lubrication interval 0 days
Time since the last operation or the
last manual lubrication 0 days
lubricated
Instruction Manual w VERTICUS 5 Compressor Units
A-39
SECURUS
Entitlement to editing from level "SERVICE"
The SECURUS and SECCANT CAN screens provide the
operating data of each individual unit. These screens are
configured in the factory and normally do not need to be
modified. If the installation is updated by replacing one or
both units, the values can only be set by expert staff and at
an appropriate access authorisation and in the configura
tion level.
With "registered, warning only" no error message "filter sa
turated" is triggered.
The statement of the delivery quantity and the cartridge
article number is required for the new preparatory calcu
lation of the used filter cartridge capacity
SECCANT CAN
Entitlement to editing from level "SERVICE"
Lubrication
For certain types of compressor, after extended periods of
standstill, pre-lubrication of the crankshaft, the pistons and
the bearings is necessary before taking them back into ser
vice. This is carried out manually in accordance with the de
tails provided in the operating instruction manual.
This page shows the lubrication interval to be complied
with and when the last manual lubrication of the compres
sors was carried out.
This value can be edited from level "CONFIG". If the value
is "0", monitoring is not carried out. The tick is a button
function, released from level "SERVICE".
When actuated we reset the counter that counts the time
since the last operation or the last manual confirmed lubri
cation.
To Next Page
