5
Mounting
In this chapter the mechanical mounting of the device into a switching ca binet is described. Information
about the «Installation space» are also to be found in this manual from page 47. The mounting consists of the
following steps:
1. Prepare mounting (drill holes / cut-out segments)
2. Install device
WARNING
The following may occur, if you do not observe this caution information:
• serious personal injury
• d eath
While executing mounting activities in any particular way, assure that no mechanic particles
(e.g. drill spans, copper cord) can intrude into the device. If possible, you should execute
drilling before mounting the device into the switching cabinet and prepare the cables outside
the switching cabinet. If this is impossible, the device should b e c overed in an adequate way.
Instrution Manual
b maXX
®
BM3400
43
Doument No.: 5.07013.03 from 206
To Next Page
Loading...