Bernina 540 - Overview Embroidery Functions; Center the Needle to the Embroidery Hoop; Moving the Hoop to the Back; Moving the Module for the Sewing Mode

Embroidering preparation
136
Overview Embroidery functions
1
2
3
4
5
1 Centering the embroidery hoop to the needle 4 Grid on/off
2 Moving the hoop to the back 5 Motif center
3 Moving the module for the sewing mode 6 Virtual Positioning (is visible while scrolling)
Center the needle to the embroidery hoop
Relocating the embroidery hoop facilitates threading when the needle is close to the embroidery hoop.
> Touch the icon «Embroidery hoop display/Embroidery hoop selection».
P
> Touch the icon «Center the needle to the embroidery hoop».
> Threading the upper thread.
> Push the button «Start/Stop» to move the embroidery hoop back to the last position.
Moving the hoop to the back
To facilitate changing the bobbin, it is recommended to move the hoop to the back before threading. This
makes it easier to open the bobbin cover.
> Touch the icon «Embroidery hoop display/Embroidery hoop selection».
P
> Touch the icon «Move the hoop to the back».
> Thread the bobbin thread (see page44).
> Push the button «Start/Stop» to move the embroidery hoop back to the last position. If necessary, pull
the upper thread back.
Moving the module for the sewing mode
The embroidery module can be positioned so that any sewing projects can be carried out even if the module
is connected.
> Touch the icon «Embroidery hoop display/Embroidery hoop selection».
> Remove the hoop.
P
> Touch the icon «Move the module for the sewing mode».