Creative sewing
78
5.9 Sewing Corners
When sewing corners, only a small section of the fabric is actually on the feed dog. Therefore it cannot grip
the fabric well. By means of the height compensation tool the fabric can be fed evenly.
> When the fabric edge is reached, stop the sewing process with needle position down.
> Raise the presser foot.
> Turn the fabric and place in desired position.
> Place 1 – 3 compensating plates as required on the right of the presser foot close to the sewing project.
> Lower the presser foot.
> Resume sewing until the sewing project is on the feed dog again.
To Next Page
Loading...
