Bernina 540 - Changing the Measuring Unit

Setup Program
53
> Touch the icon «Home».
> Touch the icon «Setup Program».
> Touch the icon «Embroidery settings».
> Touch the icon «Thread cut settings».
> Touch the switch in the upper portion of the display (1) to deactivate the automatic thread cut before the
thread is changed.
> Touch the switch in the upper portion of the display (1) again to activate the automatic thread cut before
the thread is changed.
> Touch the switch in the middle section of the display (2) again and the machine won't stop for a manual
thread cut.
> Touch the switch in the middle section of the display (2) again so that the machine will stop after about 7
stitches and the remaining thread can be cut manually.
> Touch the icons «-» or «+» (3) to adjust the length from where the connecting stitches are cut.
Changing the measuring unit
The unit of measurement in the embroidery mode can be changed from mm to inches. The default setting is
mm.
> Touch the icon «Home».
> Touch the icon «Setup Program».
> Touch the icon «Embroidery settings».
> Touch the icon «Change measuring unit».
> To change the unit of measurement in embroidery mode to inches, touch the icon «Inch» (1).