Sewing preparation
44
> Attach the empty bobbin on the winding unit so that the silvery sensor surface is down.
> Guide the thread to the left into the rear thread guide (1).
> Guide the thread around the thread pretension clockwise (2).
> Wind the thread clockwise 2 to 3 times around the empty bobbin (3).
> Pull the thread over the thread cutter at the engaging lever (4) and cut.
> Push the engaging lever (5) towards the bobbin.
– The machine winds and the display to wind the bobbin appears.
> Move the slide on the display using the touchscreen pen or the finger to adjust the winding speed.
> To stop the winding process, the engaging lever must the pressed to the right.
> Push the engaging lever towards the bobbin again to continue the winding process.
– As soon as the bobbin is full, the machine stops the winding process automatically.
> Remove the bobbin and cut the thread using the thread cutter at the engaging lever.
Threading the bobbin thread
Prerequisite:
• The needle is raised.
• The machine is switched off and the bobbin cover is opened.
To Next Page
Loading...
