Sewing preparation
35
> To remove the slide-on table, press the button at the table down and pull the slide-on table over the free
arm to the left.
2.8 Presser foot
Adjusting the presser foot position via the knee lifter of the Free Hand System
> Adjust the sitting height so that the knee lifter can be operated with the knee.
> Push the knee lifter with the knee to the right to raise the presser foot.
– Simultaneously the feed dog is lowered and the thread tension is released.
> Release the knee lifter slowly to lower the presser foot.
Adjusting the presser foot position via the button «Presser foot up/down»
> Push the button «Presser foot up/down» to raise the presser foot.
> Push the button «Presser foot up/down» again to lower the presser foot.
Changing the presser foot
> Raise the needle.
> Raise the presser foot.
> Switch the machine off and disconnect it from the power supply system.
> Push the clamping lever up (1).
> Remove the presser foot (2).
> Guide the new presser foot upwards over the cone.
> Press the clamping lever down.
To Next Page
Loading...
