Bernina 540 - Embroidering Via the Foot Control

Embroidery
158
Alterations of the upper thread tension affect the currently selected stitch pattern or embroidery motif.
Permanent alterations of the upper thread tension for the sewing mode (see page47)
and for the
embroidering mode (see page49)
can be made in the Setup Program.
Prerequisite:
• In the Setup Program the upper thread tension has been altered.
> Touch the icon «Upper thread tension».
> Move the slide using the touchscreen pen/finger to increase or reduce the upper thread tension.
> Touch the yellow-framed icon on the right side to reset the alteration to default setting.
> Touch the yellow-framed icon on the left side to reset the alteration to default setting in the Setup
Program.
16.4 Embroidering via the foot control
Embroidering via the foot control is recommended when only a short sequence has to be embroidered.
While embroidering, the foot control must be pressed down all the time.
> Press the foot control to start embroidering.