Bernina 540 - Programming the Button Thread Cutter; Programming the Button Securing

Setup Program
48
> Touch the icon «Sewing settings».
> To switch off securing stitches at the start of the pattern, set the switch to «0».
> To switch on securing stitches at the start of the pattern, set the switch to «I».
Programming the button «Thread cutter»
The automatic securing can be programed before the thread cut takes place.
> Touch the icon «Home».
> Touch the icon «Setup Program».
> Touch the icon «Sewing settings».
> Touch the icon «Program buttons and icons».
> Touch the icon «Program the button thread cutter».
> Touch the icon «Securing» to sew 4 securing stitches in place.
> Touch the icon «Alter the number of securing stitches» to program the number of securing stitches in
close succession.
> Touch the icons «-» or «+» to program the number of securing stitches.
> Touch the icon «Securing stitches in place» to program 4 securing stitches in place.
> Touch the icon «Securing» deactivate the automatic securing.
> Touch the icon «Securing» again to activate the automatic securing.
Programming the button «Securing»
Number and type of securing stitches can be programmed.
> Touch the icon «Setup Program».
> Touch the icon «Sewing settings».