Bernina 540 - Adjusting the Maximum Embroidering Speed; Setting the Embroidery Motif Position When Opening

Setup Program
50
> Touch the icon «Setup Program».
> Touch the icon «Embroidery settings».
> Touch the icon «Change upper thread tension».
> To increase the upper thread tension, slide the slider upwards or touch the icon «+».
> To decrease the upper thread tension, slide the slider downwards or touch the icon «-».
Adjusting the maximum embroidering speed
You can use this function to reduce the maximum speed.
> Touch the icon «Home».
> Touch the icon «Setup Program».
> Touch the icon «Embroidery settings».
RPM
> Touch the icon «Change maximum speed».
> To decrease the embroidery speed, slide the slider to the left or touch the icon «-».
> To increase the maximum embroidery speed, slide the slider to the right or touch the icon «+».
Setting the embroidery motif position when opening
As the default setting, opened embroidery motifs are always displayed in the center of the hoop. You can
use the switch «
Restore saved embroidery motif position» to set that embroidery motifs are opened at the
position in the hoop at which they had been saved in the BERNINA stitch software.
> Tap «Home».
> Touch the icon «Setup Program».
> Touch the icon «Embroidery settings».
> Touch the icon «Center the embroidery motif».
> To open the embroidery motif at the saved position, set the switch «Restore saved embroidery motif
position»
to «I».
> To open the embroidery motif in the center of the hoop, set the switch «Restore saved embroidery motif
position»
to «0I».