Setup Program
61
> Touch the icon «Calibrate the Buttonhole foot No. 3A».
> Lower the Buttonhole foot with slide No. 3A.
> To start the calibration, touch the button «Start/Stop».
> After the calibration is finished, close the window.
Updating the machine Firmware
The machine's current firmware and detailed step-by-step instructions for the update process can be
downloaded from www.bernina.com
. In general, personal data and settings are automatically transferred
during a firmware update. For reasons of safety, it is also recommended to save data and settings on a
BERNINA USB stick (optional accessory) before the firmware update is started. If personal data and settings
should get lost during a firmware update, they can be transferred to the machine again afterwards.
NOTICE
The BERNINA USB stick (optional accessory) has been removed too early
Firmware has not been updated and the machine cannot be used.
> Remove the BERNINA USB stick (optional accessory) only after the update has been completed
successfully.
> Insert the BERNINA USB stick (optional accessory), FAT32 formatted, providing the latest software into
the port.
> Touch the icon «Home».
> Touch the icon «Setup Program».
> Touch the icon «Machine settings».
> Touch the icon «Maintenance/Update».
> Touch the icon «Update the machine».
> Touch the icon «Save data on USB stick».
– The icon is checkmarked in green.
> To start the firmware update, touch the icon «Update».
To Next Page
