Embroidering preparation
127
13 Embroidering preparation
13.1 Attaching the Module
NOTICE
Transporting the embroidery module
Damage to the embroidery module connection and machine.
> Remove the embroidery module before transporting the machine.
Prerequisite:
• The slide-on table must not be attached.
> Make sure that the module and the machine are placed on a stable, even surface.
> Make sure that there is enough space around to allow the unimpeded movement of the embroidery arm.
> Lift the embroidery module on the left.
> Carefully push the embroidery module from left to right into the embroidery module connection of the
machine (1).
> To remove the embroidery module, lift it on the left side and pull it carefully to the left.
To Next Page
Loading...
