Bernina 735 - Embroidery Sequence Control When Thread Breaks; Cutting Connecting Stitches; Reducing Color Changes; Multi-Colored Embroidery Motif On;Off

Creative embroidering
155
Embroidery sequence control when thread breaks
If the thread breaks, the needle can be repositioned in the embroidery motif using the function Embroidery
Sequence Control.
> Select an embroidery motif.
> Tap «Embroidery».
> Tap «Embroidery Sequence Control».
– In the left section of the display a compact view of the embroidery motif is displayed. On the right side
the enlarged embroidery motif is displayed.
> Select the desired position in the compact view.
> Turn the «Upper Multi-function knob» to move the hoop stitch by stitch.
> Turn the «Lower Multi-function knob» to move the hoop in large steps.
– The number in the yellow-outlined icon indicates the number of stitches within the embroidery
sequence.
> To select the desired stitch by entry, tap the icon «Stitch Position via number».
Cutting connecting stitches
The function is activated by default and the connecting stitches are cut automatically. When the function is
deactivated, the connecting stitches between the embroidery motifs must be cut manually.
> Select an embroidery motif.
> Tap «Embroidery».
> To deactivate the function, tap the yellow-outlined icon «Cut Connecting Stitches».
> To activate the function, tap the yellow-outlined icon «Cut Connecting Stitches» again.
Reducing color changes
When the embroidery motifs overlap, the color changes cannot be reduced.
> Select an embroidery motif.
> Tap «Embroidery».
> Tap «Reduce Color Changes».
– Identical colors of the embroidery motif are collected to one color.
Multi-colored embroidery motif on/off
Multi-colored embroidery motifs can also be embroidered in one color.
> Select an embroidery motif.
> Tap «Embroidery».