Bernina 735 - Programming the Securing Stitches; Adjusting the Thread Cut

Setup Program
54
> Tap «Setup Program».
> Tap «Embroidery settings».
> Tap «Thread away».
> Activating/Deactivating the function thread away.
Programming the securing stitches
Embroidery motifs are programmed either with or without securing stitches. If an embroidery motif has
programmed securing stitches, they will be embroidered. If the embroidery motif is programmed with
securing stitches, the securing stitches can be removed in the BERNINA Embroidery Software.
The machine recognizes when no securing stitches are programmed and adds them. If no securing stitches
are wanted, they can be deactivated.
> Tap «Setup Program».
> Tap «Embroidery settings».
> Tap «Securing Stitches».
> To deactivate the securing stitches at the start, switch off the switch in the upper section.
– If the embroidery motif doesn't have any programmed securing stitches, none are embroidered.
> Turn on the switch in the upper section to deactivate the securing stitches at the start.
– If the embroidery motif doesn't have any programmed securing stitches, the securing stitches are
added and will be embroidered.
> Turn off the switch in the lower section to deactivate the securing stitches at the end.
– If the embroidery motif doesn't have any programmed securing stitches, none are embroidered.
> Turn on the switch in the lower section to activate the securing stitches at the end.
– If the embroidery motif doesn't have any programmed securing stitches, the securing stitches are
added and will be embroidered.
Adjusting the thread cut
> Tap «Setup Program».
> Tap «Embroidery settings».