Care and maintenance
164
> To start the firmware update, tap «Update».
Note:
The update may take several minutes. Do not switch off the machine or remove the USB stick
during the update.
– The machine restarts. When the update is complete, a message appears.
Recovering saved data
If personal data and settings after a software update are not available anymore, they can be transferred to
the machine again afterwards.
> Insert the BERNINA USB stick providing the saved data and settings into the USB port of the machine.
> Tap «Setup Program».
> Tap «Machine Settings».
> Tap «Maintenance/Updates».
> Tap «Machine Update».
NOTICE
The BERNINA USB stick (optional accessory) has been removed too early
Saved data cannot be transferred and the machine cannot be used.
> Remove the BERNINA USB stick (optional accessory) only after the saved data has been transferred
successfully.
> Tap «Load Data».
– After the data has been transferred, a green tick is temporarily displayed.
17.2 Machine
Cleaning the display
> Clean the display in the switched off status with a soft slightly damp microfiber cloth.
Cleaning the feed dog
Remaining threads under the stitch plate must occasionally be removed.
> Raise the needle and presser foot.
CAUTION
Electronically driven components
Risk of injury near the needle and the hook.
> Switch the machine off and disconnect it from the power supply system.
> Remove the needle and presser foot.
To Next Page
Loading...
