Bernina 735 - Overview Embroidery Functions; Center the Needle to the Embroidery Hoop; Moving the Hoop to the Back; Moving the Module for the Sewing Mode

Embroidering preparation
136
Overview Embroidery functions
1
2
3
4
5
6
1 «Center Embroidery Hoop to Needle» 4 «Grid On/Off»
2 «Move Hoop to the Back» 5 «Center Motif»
3 «Move Hoop to the Left» 6 «Virtual Positioning»
Center the needle to the embroidery hoop
Relocating the embroidery hoop facilitates threading when the needle is close to the embroidery hoop.
> Tap «Hoop Indicator/Select Hoop».
P
> Tap «Center Embroidery Hoop to Needle».
> Thread the upper thread.
> To move the hoop back to its previous position, push the button «Start/Stop».
Moving the hoop to the back
To facilitate changing the bobbin, it is recommended to move the hoop to the back before threading. This
makes it easier to open the bobbin cover.
> Tap «Hoop Indicator/Select Hoop».
P
> Tap «Move Hoop to the Back».
> Thread the bobbin thread. (see page45)
> To move the hoop back to its previous position, push the button «Start/Stop». If necessary, pull back the
upper thread.
Moving the module for the sewing mode
The embroidery module can be positioned so that any sewing projects can be carried out even if the module
is connected.
> Tap «Hoop Indicator/Select Hoop».
> Remove the embroidery hoop.