Bernina 735 - Deleting Motifs on the BERNINA USB Stick; Calibrating the Buttonhole Foot No. 3 A; Packing the Embroidery Module

Setup Program
60
Deleting motifs on the BERNINA USB Stick
When motifs which won't be needed anymore are saved on the BERNINA USB Stick, the stick can be
connected to the machine and the data can be deleted.
> Insert the BERNINA USB stick into the USB port of the machine.
> Tap «Setup Program».
> Tap «Machine Settings».
> Tap «Factory Setting».
> Tap «Deleting USB Stick».
> Tap «Confirm».
Calibrating the Buttonhole foot No. 3A
The Buttonhole foot with slide#3A is calibrated to the machine and they should only be used both
together.
Prerequisite:
• The Buttonhole foot with slide#3A is fitted.
• The needle is not threaded.
> Tap «Setup Program».
> Tap «Machine Settings».
> Tap «Maintenance/Updates».
> Tap «Calibrating the Buttonhole foot#3A».
> To start the calibration, push the «Start/Stop» button.
Packing the embroidery module
To pack the embroidery module into the original packaging without moving the embroidery arm manually,
the embroidery arm needs to be brought to its packing position.
Prerequisite:
• The embroidery module is connected with the machine.