Bernina 735 - Embroidery Settings Configuration

Setup Program
50
Programming the button «Thread cutter»
The automatic securing can be programed before the thread cut takes place.
> Tap «Setup Program».
> Tap «Sewing settings».
> Tap «Programming buttons and icons».
> Tap «Programming the button Thread cutter».
> To sew 4 securing stitches in place, tap «Securing Stitches».
> To program subsequent securing stitches, tap «Securing stitches in close succession».
> To program the number of securing stitches, tap «Minus» or «Plus».
> To program 4 securing stitches in place, tap «Securing stitches in place».
> To deactivate the automatic securing, tap «Securing Stitches».
> To activate the automatic securing, tap «Securing Stitches» again.
Adjusting the presser foot position with needle stop down
With lowered needle, 3 different presser foot position can be selected: the presser foot lowered, the presser
foot is raised to hovering position and the presser foot is raised to its maximum height.
> Tap «Setup Program».
> Tap «Sewing settings».
> Tap «Programming buttons and icons».
> Tap «Pressure foot position with Needle Stop Down».
> Select the desired presser foot position.