Errors and faults
172
Message on the display Cause Solution
The firmware update has failed. The latest firmware version
cannot be found on the USB
stick.
> Make sure that the compressed zip file has been
unzipped for the firmware update.
> Check whether the data for the software update is
saved directly on the data medium and not in a file on
the USB stick.
> Updating Firmware.
The machine needs cleaning/
lubricating.
> Clean the machine.
> Lubricate the machine.
Important information on lubricating:
> Too much oil may stain the fabric and the thread.
> After lubricating, sew/embroider a test piece first.
The automatic thread cutter (at
the thread catcher) needs
cleaning.
The automatic thread cutter
needs cleaning. The message
appears every time when the
machine is started as soon as
1000 cutting cycles have been
carried out.
> Tap «Confirm».
– The machine calls up the function «Clean the thread
catcher».
> Clean the thread catcher according to the instructions
on the display.
– The counter for the cutting cycles is reset.
It is time for the regular
maintenance. Please contact your
authorized BERNINA dealer to
make an appointment.
The machine needs maintenance.
The message appears after the
programmed service interval has
expired.
Important information: When
cleaning and maintenance work
is carried out as instructed, the
functionality and long service life
of the machine is ensured.
Ignoring the terms can affect the
operating life and restrict the
guarantee. The cost allocation for
maintenance work is regulated
nationally. Consult your
authorized BERNINA dealer or
your service center for more
details.
> Contact an authorized BERNINA dealer.
> Delete the message temporarily by touching the icon
«ESC».
After the third deletion, the message is not displayed until
the next service interval is reached.
To Next Page
Loading...
