Field Description
• B% C
Action Only for Type of traffic = ?%1# 2 )3*!
Select which data packets are to be excluded by NAT.
Possible values:
• ?%1 (default value): All the data packets that match the
following parameters that are to be configured (protocol,
source IP address/network mask, destination IP address/net-
mask, etc.) are excluded by NAT.
• 5 ?%1: All the data packets that do not match the
following parameters that are to be configured (protocol,
source IP address/network mask, destination IP address/net-
mask, etc.) are excluded by NAT.
Protocol Only for certain services.
Not for Type of traffic = ## % )3*! and NAT
method = $11 %, % % or +
% %. In this case UDP is automatically defined.
Select a protocol. According to the selected Service, different
protocols are available.
Possible values:
• 3( (default value)
• 3@
• 6
•
•
•
• A
• @'
• 6'
• '
•
• A
•
11 Networking bintec elmeg GmbH
214 bintec RS Series
To Next Page
Loading...
