Biolight Meditech S12 Vet - Page 111

S12 Vet Monitor User’s Manual
9-5

3. Set 【RRSource】.When you select 【Auto】, the system automatically selects
the RR source according to the priority.
RR source is first CO2, and then ECG,
and SpO2.
When the current RR source does not have valid measurement, the
system automatically switches the【RR
Source】to【Auto】.
9.5.3. Selecting Respiration Lead
You can set up respiration lead to get the best respiratory waveform. The steps to set
up breathing leads are as follows:
1. Select the RESP parameter area or waveform area to enter the 【RESP】menu.
2. Select【Setup】submenu.
3. Set 【RESP Lead】.
If the respiratory waveform is still poor after adjusting the
respiration lead or the respiration rate measurement is suspected to be
inaccurate, you can adjust the electrode position.
9.5.4. Setting RESP Waveform Gain
You can adjust the RESP waveform gain to better view the waveform amplitude. The
steps to set the RESP waveform gain are as follows:
1. Select the RESP parameter area or waveform area to enter the 【RESP】menu.
2. Select【Setup】submenu.
3. Set【Gain】.
9.5.5. Setting the RESP Waveform Speed
To set the RESP waveform speed, follow this procedure:
1. Select the RESP parameter area or waveform area to enter the 【RESP】menu.
2. Select【Setup】submenu.
3. Set【Wave Speed】.
9.5.6. Setting the Auto Detection Switch
To set the auto detection switch, follow this procedure:
1. Select the RESP parameter area or waveform area to enter the 【RESP】menu.