S12 Vet Monitor User’s Manual
11-2
here.
(4) TEMP value
(5) TEMP Difference (ΔT): TEMP Difference between two temperature sites. It displays
only when ΔT is switched on.
11.4. Preparing for TEMP Monitoring
Please follow these steps to prepare TEMP measurement:
1. According to the type of patient and the measurement site, select the
appropriate temperature probe.
2. Insert the probe or extension cable into the temperature probe connector. If a
disposable probe is used, connect the probe and extension cable.
3. Attach the probe to the patient correctly.
4. Select an appropriate temperature label.
11.5. TEMP Settings
11.5.1. Setting TEMP Alarm
To set the temperature alarm, follow this procedure:
1. Select the TEMP parameter area to enter the 【TEMP】menu.
2. Select【Alarm】submenu.
3. If the alarm setting is protected by password, enter the password. For detail,
please refer to 7.6.2 Changing Alarm Setup Protection Mode.
4. Set alarms as needed.
11.5.2. Setting TEMP Label
Select the temperature label according to the measurement site. To do so, follow this
procedure：
1. Select the TEMP parameter area to enter the【TEMP】menu.
2. Select【Setup】submenu.
3. Set the TEMP label name according to the measurement site.
To Next Page
Loading...