Biolight Meditech S12 Vet - Appendix D Alarm Message; Physiological Alarm

S12 Vet Monitor User’s Manual
48
Appendix D Alarm Message
This chapter lists some of the most important physiological and technical alarm
information, and some alarm information may not be listed.
D.1 Physiological alarm
D.1.1 General physiological alarm
Alarm messages Default priority Cause and solution
XX High MED
The measured value of the corresponding
parameter is higher than the alarm high limit.
Please check the patient’s physiological condition
and confirm whether the patient type and alarm
limit settings are applicable to the patient.
XX Low MED
The measured value of the corresponding
parameter is lower than the alarm high limit.
Please check the patient’s physiological condition
and confirm whether the patient type and alarm
limit settings are applicable to the patient.
Note: XX represents the nominal name of physiological parameter, such as HR, ST, RR,
SpO2 or PR, etc.
D.1.2 Arrhythmia alarm information
Alarm messages Default priority Alarm messages Default priority
Asystole HIGH Pauses/min High MED
Vent Fib/Tach HIGH Run PVCs MED
V-Tach HIGH Couplet LOW
Vent Brady HIGH Bigeminy LOW
Extreme Tachy HIGH Trigeminy LOW
Extreme Brady HIGH Frequent PVCs LOW
R on T MED PVC LOW