S12 Vet Monitor User’s Manual
14-7
14.7.2. Setting the temperature unit
You can change the unit of temperature, following these steps:
1. Selecting C.O. parameters area for enter the 【C.O.】 menu.
2. Select the 【Setup】 submenu.
3. Set the body temperature 【Temp Unit】.
14.7.3. Setting the C.O. Measurement Value Invalid Time
If the measured value of C.O. is not updated once more within setting time, its
measured value is displayed as a hollow number, which indicates the current measured
value has expired. You could set up the time when the C.O. measurement value expires,
following steps:
1. Select 【Main Menu】 quick key→select 【Maintenance】 from 【System】
column→input password→Enter.
2. Select 【Module】 submenu.
3. Select 【Other】 submenu.
4. Set 【C.O. Invalid Time】.
NOTE:
When the measured value of the non-continuous measurement parameter is
displayed as a hollow number, it means that the measurement result has
expired. It is not recommended.
Other settings, such as patient information (height, weight), catheter coefficient,
measurement mode, and injection temperature source, see 14.6.2 Setting the
C.O. Measurement.
14.8. C.O. Troubleshooting
This section describes the problems you may encounter during using. You can refer
to the following table for troubleshooting. If the problem still persists, please contact
maintenance staff.
To Next Page
Loading...