S12 Vet Monitor User’s Manual
16-5
If you need to replace the liquid medicine container, please follow the steps as
below:
1) When the liquid stop clamp of the DM module is closed, remove the liquid
medicine container from the infusion pipeline;
2) Connect the infusion pipeline with a new liquid medicine container;
3) Open the liquid stop clamp through the “Reset” button on the DM module,
and then press the “Start/Stop” button to continue drip monitoring.
16.4. DM module indicator
Status Indicator
Drip monitoring The green light is always on and flickers with
drops of liquid.
Suspension or stop of infusion Yellow is always bright.
Infusion completed and stopped Red light flashing (2Hz)
16.5. DM display
(1) Parameter Label
(2) Drip rate unit (main unit)
(3) The value of drip rate
(4) The value of flow rate
(5) Flow rate unit
(6) Working state diagram
The green dot blinks during drip monitoring, and when when drip monitor is
stopped, the yellow dot light without flashing; when the infusion is completed, the whole
symbol light white and red alternately.
1
3
2
4
6
5
To Next Page
Loading...