Biolight Meditech S12 Vet - Voice Assistant

S12 Vet Monitor User’s Manual
3-15 

3.8.3. Setting the Timer
You can set each timer independently. To set the timer, follow this procedure:
1. Select the timer area to enter the
【 Timer 】 menu.
2. Set【Timer Type】:
 【Normal】: The timer is timed according to the present 【Run Time】.
Stop timing when running time is reached.
 【Cycled】: The timer cycles, that is, the timer counts according to the
preset 【Run Time】, and starts timing again after reaching the run time. The
timer area displays the number of timer cycles.
 【Unlimited】: The timer displays the time elapsed since the timer was
started.
3. Set【Direction】.
4. Set【Run Time】.
5. Set【Reminder Volume】
. When the remaining time is 10 seconds, the monitor
issues a reminder tone and the timer flashes in red, prompting you that the run
time is to expire.
CAUTION：
 Cannot change timer settings when a timer is running.
 Set【Direction】, 【Run Time】and【Reminder Volume】only for【Normal】
or【Cycled】.
3.9. Voice Assistant
The voice assistant can be used as an auxiliary input interface. You can issue specific
control commands to the monitor via voice. After the monitor recognizes the command, it
performs the corresponding operation function.
The method of operating the voice assistant as following:
1. Select
【
Voice Assistant
】
quick key, open the voice assistant function, the icon
"
" will display on the top of status bar.