S12 Vet Monitor User’s Manual
3-16
2.
Say the wake-up words.
At this time, the top status bar will display the "
" icon, indicating that the monitor is in the state of voice recognition control
command.
3.
When the control command is spoken, the monitor will recognize the
command and perform the corresponding operation, at this time, "
" icon
disappears and the " " icon is displayed.
CAUTION：
Every time before you say a control command, you must say the wake-up word
to wake up the voice assistant at first. After waking up
（
the top status bar
displays the "
" icon
）
, if the control command is not spoken within 7
seconds, the voice assistant will enter the sleep state again (top The status bar
displays the "
" icon
）
, you need to re-execute the
“
Wake-up
”
→
“
Control Command
”
voice operation.
When using the voice assistant, try to be as close as possible to the monitor.
Please avoid using the voice assistant in noisy environments.
NOTE：
The specific wake-up words and supported voice commands will show in the
voice assistant screen.
To Next Page
Loading...