Biolight Meditech S12 Vet - NIBP Settings

S12 Vet Monitor User’s Manual
12-8

Task Via quick key Via NIBP menu
Start STAT
measurement
Select【NIBP STAT】quick key
Select【STAT】
Stop the current NIBP
measurements
Select【NIBP Start/Stop】quick
key
Select【Stop】
End Auto NIBP or
Sequence
measurement
Select【NIBP Stop All】quick key
Select【Stop All】
Stop STAT
measurement
Select【NIBP Start/Stop】quick key
Select【Stop】or 【Stop All】
12.8. NIBP Settings
12.8.1. Setting the NIBP Alarm
To set the NIBP alarm properties, follow this procedure:
1. Select the NIBP parameter area to enter the【NIBP】menu.
2. Select【Alarm】submenu.
3. If the alarm setting is protected by password, enter the password. For detail,
please refer to 7.6.2 Changing Alarm Setup Protection Mode.
4. Set alarms as needed.
12.8.2. Setting the Initial Cuff Inflation Pressure
You can manually set the initial inflation pressure of the cuff, follow this procedure:
1. Select the NIBP parameter area to enter the【NIBP】menu.
2. Select【Setup】submenu.
3. Set【Initial Pressure】:
Select the appropriate cuff pressure value as needed.
12.8.3. Setting the NIBP Interval
For Auto NIBP measurement, you need to set the interval between two NIBP
measurements. To set the NIBP interval, follow this procedure:
1. Select the NIBP parameter area to enter the【NIBP】menu.
2. Select【Setup】submenu.