S12 Vet Monitor User’s Manual
7-9
【
Setup
】
.
2. Select【Apnea Delay】to set apnea alarm delay time.
7.6.5. Setting Alarm Waveform Length
You can set the length of the waveform needs to be output when an alarm occurs, the
setting steps are as follows:
1. Enter【Setup】interface in either of the following ways:
Select【Alarm Setup】quick key→Select【Setup】submenu.
Select【Main Menu】quick key→from 【Alarm】 column to select
【Setup】.
Select【Main Menu】quick key→from【Report】column to select
【Record Setup】.
2. Set【Alarm Record Duration】.
7.6.6. Setting CMS Disconnect Alarm Switch
You can set whether to alarm when the monitor and the CMS are disconnected. This
function is enabled by default. The setting method is as follows:
1. Select 【 Main Menu 】 quick key→from 【 System 】 column to select
【Maintenance】→input maintenance password→Enter.
2. Select【Alarm】submenu→【Other】submenu.
3. Open or Close 【CMS
Disconnected】.
When the 【CMS Disconnected】 switch is turned on, the technical alarm
will be generated when the monitor and the CMS are disconnected after
successful connection.
7.7. Alarm Pause
When the alarm is paused, it has the following characteristics:
Shield all physiological alarms within the set time.
The technical alarm sound is paused, but the alarm light and alarm
information are still displayed.
To Next Page
Loading...