S12 Vet Monitor User’s Manual
19-3
19.6. Setting the Recorder
This section describes the definition of the main setting items. Users can refer to
these definitions to select other similar setting items in the device according to their
needs.
Select 【Main Menu】 → from 【Report】 column select 【Record Setup】to
enter according corresponding menu.
19.6.1. Selecting the recorded waveform
The recorder can output up to 3 waveforms at a time. In the 【Record Setup】menu,
you can select 【Waveform 1】, 【Waveform 2】, 【Waveform 3】 in turn, and then
select the name of the waveform in the pop-up list. Select 【Close】 to turn off the output
of 1 waveform. These settings apply to real-time recording and periodic recording.
19.6.2. Setting the duration of real-time recording
When starting a real-time recording, the length of recording depends on your setting
of recording duration.
1. Open the 【Record Setup】 menu.
2. Set 【Record Duration】 to:
【8s】: Record the waveform of 4 seconds before and after the current
time.
【Continue】: Record the waveform 5 seconds before and after the
current time until you manually stop recording.
19.6.3. Setting the interval for periodic recording
You can set a certain time interval, and the recorder automatically starts recording
according to the set time interval.
1. Open the 【Record Setup】 menu.
2. Set 【Cycle Record Interval】.
3. After the setting is completed, the recorder starts each recording at the set
interval.
To Next Page
Loading...