Biolight Meditech S12 Vet - Page 142

S12 Vet Monitor User’s Manual
13-8

c) The patient has acute right ventricular dysfunction (i.e., pulmonary heart
disease)
13.5.7. Changing the pressure unit:
You can change the unit of pressure by following these steps:
1. Select the IBP parameter area or waveform area to enter the corresponding
pressure menu.
2. Select【Setup】submenu.
3. Set IBP 【Unit】 if needed.
13.5.8. Overlapping IBP Waveforms
Please following steps below, set up the IBP waveform overlay display:
1. Enter the 【Screen Layout】page, following method：
 Select 【Screen Layout】 quick key → select 【Screen Layout】
submenu.
 Select 【Main Menu】 quick key → select 【Screen Layout】 from
the 【Display】 column.
2. Select 【IBP Overlap】 in the waveform parameter area and select the IBP
waveform to be overlapped on the same line on the left side.
3. Repeat the operation of step 2 at other locations with waveform parameter
areas if needed.
4. Select
to exit Setup page. The overlapped IBP waveform can be displayed
on the main interface.
You can open the 【IBP Overlap】 menu by selecting the IBP waveform area to be
overlapped on the main screen. In the 【IBP Overlap】 menu, you can make the
following settings:
 Scale