II
Manufacturer's Responsibility
Only under the following circumstances will manufacturer be responsible for the safety,
reliability and performance of the instrument:
All the installation, expansion, readjustment, renovation or repairs are conducted by
the personnel certified by manufacturer.
All the replaced components, assorted accessories and consumables involved in
maintenance are original or approved by Biolight.
The storage condition, operation condition and electrical status of the instrument
conform to the product specification.
The electrical installation of the relevant room
complies with the applicable national and local requirements;
The instrument is used in accordance with the user’s manual.
Signs in this manual：
WARNING: Indicates a potential hazard or unsafe practice that, if not avoided,
will result in death or serious injury.
CAUTION: Indicates a potential hazard or unsafe practice that, if not avoided,
could result in minor injury or product/property damage.
NOTE: Provides application tips or other useful information to ensure that you get
the most from your product.
Warranty and maintenance service
The warranty period for the purchased products shall be subject to the sales contract.
The consumables means disposable consumables material needed to be replaced after
using every time or vulnerable material needed to be replaced regularly. The consumables
don’t have warranty service.
The warranty period starts from the "installation date" filled in on the attached
<Equipment Warranty Card>, which is the only proof to calculate the warranty period.
To Next Page
Loading...