S12 Vet Monitor User’s Manual
7-5
Select 【Main Menu】 quick key→from【Alarm】column to select【Limit】.
2. Select parameter submenu to set the alarm according to the required. You can
also set the alarm for individual parameters from the parameters menu.
7.6.2. Changing Alarm Setup Protection Mode
You can change the password protection mode of the alarm settings and arrhythmia
settings as follows:
1. Select 【 Main Menu 】 quick key→from 【 System 】 column to select
【Maintenance】→input maintenance password→Enter.
2. Select【Authorization】submenu.
3. Change the password protection mode of the alarm settings.
【No Password】: Change alarm setups to not be password protected.
【Password】: Change alarm switch, alarm limit and alarm level to be
protected by password.
If you use password to access alarm and arrhythmia alarm related settings, you can
set the valid time of the password, beyond which you need to re-enter the password. For
details, please refer to 5.9 Setting Password Valid Time.
7.6.3. Setting Alarm Sound Properties
7.6.3.1. Setting Alarm Volume
1. Enter【Setup】interface in either of the following ways:
Select【Alarm Setup】quick key→Select【Setup】submenu.
Select【Main Menu】quick key→from【Alarm】column to select 【Setup】.
2. Set 【Alarm Volume】. The alarm volume range is X-10, in which X is the
minimum volume, depending on the set minimum alarm volume, and 10 is the
maximum volume.
3. Set【High Alarm Volume】.
4. Set【Reminder Volume】.
NOTE：
To Next Page
Loading...