BK Precision 8500B Series - Servicing and Fuse Replacement; Continued Safe Use Recommendations

14
Measure Commands
4.1 MEASure[:SCALar]:VOLTage[:DC]? 14
4.2 MEASure[:SCALar]:VOLTage:MAXimum? 14
4.3 MEASure[:SCALar]:VOLTage:MINimum? 14
4.4 MEASure[:SCALar]:VOLTage:PTPeak? 14
4.5 MEASure[:SCALar]:CURRent[:DC]? 15
4.6 MEASure[:SCALar]:CURRent:MAXimum? 15
4.7 MEASure[:SCALar]:CURRent:MINimum? 15
4.8 MEASure[:SCALar]:CURRent:PTPeak? 15
4.9 MEASure[:SCALar]:POWer[:DC]? 15
4.10 MEAS[:SCALar]:RESistance[:DC]? 16
This signal measure command is used to get the read back value. You can use this command to control the measurement
process.
4.1 MEASure[:SCALar]:VOLTage[:DC]?
This command is used to query the average voltage of the electronic load.
Command Syntax MEASure[:SCALar]:VOLTage[:DC]?
Parameters None
Example MEAS:VOLT?
Query Response <NR2>
4.2 MEASure[:SCALar]:VOLTage:MAXimum?
This command is used to query the peak voltage of the electronic load.
Command Syntax MEASure[:SCALar]:VOLTage:MAXimum?
Parameters None
Example MEAS:VOLT:MAX?
Query Response <NR2>
4.3 MEASure[:SCALar]:VOLTage:MINimum?
This command is used to query the minimum voltage of the electronic load.
MEASure[:SCALar]:VOLTage:MINimum?
MEAS:VOLT:MIN?
<NR2>
4.4 MEASure[:SCALar]:VOLTage:PTPeak?
This command is used to query the voltage peak-to-peak value.
Command Syntax MEASure[:SCALar]:VOLTage:PTPeak?