BK Precision 8500B Series - 6.1.6 CW Mode

38
10.8 TIMing:TSTart:LEVel
This command is used to set the trigger level for the start test.
Command Syntax TIMing:TSTart:LEVel <Nrf+>
Parameters Depends on the start trigger source, which is the setting of the Timing:TSTart:SOURce com-
mand.
Example TIM:TST:LEV 1
Query Syntax TIMing:TSTart:LEVel?
Query Response <NR2>
10.9 TIMing:TEND:SOURce
This command sets the trigger source for ending the test.
Command Syntax TIMing:TEND:SOURce <source>
Parameters VOLT- CURR- EXT
Example TIM:TEND:SOUR VOLT
Query Syntax TIMing:TEND:SOURce?
Query Response <source>
10.10 TIMing:TEND:EDGE
This command is used to set the trigger edge of the end test.
Command Syntax TIMing:TEND:EDGE <edge>
Parameters RISE- FALL
Example TIM:TEND:EDGE RISE
Query Syntax TIMing:TEND:EDGE?
Query Response <edge>
10.11 TIMing:TEND:LEVel
This command sets the trigger level for ending the test.
Command Syntax TIMing:TEND:LEVel <Nrf+>
Parameters Depends on the end trigger source, which is the setting of the Timing:TEND:SOURce com-
mand.
Example TIM:TEND:LEV 1
Query Syntax TIMing:TEND:LEVel?
Returned Parameters <NR2>