21
Peak Testing Commands
6.1 PEAK[:STATe] <bool> 21
6.2 PEAK CLEar 21
6.3 PEAK:VOLTage:MAXimum? 21
6.4 PEAK:VOLTage:MINimum? 21
6.5 PEAK:CURRent:MAXimum? 21
6.6 PEAK:CURRent:MINimum? 22
These commands are used to read the maximum/minimum value after startup test. Peak value recording is automatically
cleared when the Peak test is started.
6.1 PEAK[:STATe] <bool>
This command is used to set the peak test status.
Command Syntax PEAK[:STATe] <bool>
Example Peak:ON
6.2 PEAK CLEar
This command is used to clear the peak record.
Command Syntax PEAK CLEar
Example Peak CLE
6.3 PEAK:VOLTage:MAXimum?
This command is used to query the maximum voltage.
Command Syntax PEAK:VOLTage:MAXimum?
Example PEAK:VOLT:MAX?
Query Response <NR2>
6.4 PEAK:VOLTage:MINimum?
This command is used to query the minimum voltage.
Command Syntax PEAK:VOLTage:MINimum?
54
Peak Testing Commands
Example PEAK:VOLT:MIN?
Query Response <NR2>
6.5 PEAK:CURRent:MAXimum?
This command is used to query the maximum current.
To Next Page
Loading...
