BK Precision 8500B Series - Getting Started; 4.1 Input Power and Fuse Requirements

23
Input Settings
7.1 [SOURce:]INPut <bool> 23
7.2 [SOURce:]INPut:SHORt <bool> 23
7.3 [SOURce:]FUNCtion <function> [SOURce:]MODE <function> 24
7.4 [SOURce:]VOLTage:RANGe <NRf+> 24
7.5 [SOURce:]VOLTage:RANGe:AUTO[:STATe] 25
7.6 [SOURce:]VOLTage:[LEVel:]ON <NRf+> 25
7.7 [SOURce:]Voltage:[LEVel:]OFF <NRf+> 25
7.8 [SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude] <NRf+> 26
7.9 [SOURce:]CURRent:RANGe <NRf+> 26
7.10 [SOURce:]CURRent:SLEW[:BOTH] <NRf+> 26
7.11 [SOURce:]CURRent:SLEW:RISE <NRf+> 27
7.12 [SOURce:]CURRent:SLEW:FALL <NRf+> 27
7.13 [SOURce:]CURRent:PROTection[:LEVel] <NRf+> 27
7.14 [SOURce:]CURRent[:LEVel][:IMMediate][:AMPLitude] <NRf+> 28
7.15 [SOURce:]POWer:PROTection[:LEVel] <NRf+> 28
7.16 [SOURce:]POWer[:LEVel][:IMMediate][:AMPLitude] <NRf+> 28
7.17 [SOURce:]RESistance[:LEVel][:IMMediate][:AMPLitude] <NRf+> 29
7.18 [SOURce:]RESistance[:LEVel][:IMMediate][:AMPLitude]? 29
7.19 [SOURce:]DYNamic:HIGH[:LEVel] <NRf+> 29
7.20 [SOURce:]DYNamic:HIGH:DWELl <NRf+> 30
7.21 [SOURce:]DYNamic:LOW[:LEVel] <NRf+> 30
7.22 [SOURce:]DYNamic:LOW:DWELl <NRf+> 30
7.23 [SOURce:]DYNamic:SLEW <NRf+> 31
7.24 [SOURce:]DYNamic:SLEW:RISE <NRf+> 31
7.25 [SOURce:]DYNamic:SLEW:FALL <NRf+> 31
7.26 [SOURce:]DYNamic:MODE <mode> 32
These commands control the input of the electronic load. The INPut, CURRent, RESistance and VOLTage commands
program the actual input current, resistance, and voltage.
7.1 [SOURce:]INPut <bool>
This command is used to set the input status.
Command Syntax [SOURce:]INPut <bool>
Parameters 0 - 1 - OFF - ON
*RST Value OFF
Example INP 1
Query Syntax INPut[:STATe]?
Query Response 0 - 1
7.2 [SOURce:]INPut:SHORt <bool>
This command is used to set the status of short circuit function.
Command Syntax [SOURce:]INPut:SHORt <bool>