50
12.23 Enable/Disable LOCAL control mode. (55H)
Byte Description
1 AAh
2 Address (0-31)
3 Command 55H
4 State of LOCAL button (0:disable, 1:enable)
5-25 Reserved
26 Checksum
12.24 Enable/Disable remote sense mode. (56H/57H)
Byte Description
1 AAh
2 Address (0-31, 0XFF)
3 Command 56H/57H
4 Remote mode state (0:OFF, 1:ON)
5 to 25 Reserved
26 Checksum
12.25 Set/Read trigger source. (58H/59H)
Byte Description
1 AAh
2 Address (0-31, 0XFF)
3 Command 58H/59H
4 Trigger mode (0:Manual, 1: External, 2:Bus, 3:Hold)
5-25 Reserved
26 Checksum
12.26 Send a trigger signal to trigging the electronic load. (5AH)
Byte Description
1 AAh
2 Address (0-31, 0XFF)
3 Command 5AH
4-25 Reserved
26 Checksum
12.27 Saving/Recall user’s setting value in appointed memory area for recall.
(5BH/5CH)
To Next Page
Loading...
