It's worth mentioning that the "program audio" setting is only available on URSA Mini Pro 4.6K.
ATEM Camera ID
If you’re using URSA Mini with an ATEM Switcher and want your camera to receive tally signals
from the switcher, you’ll need to set the camera number on your camera. This ensures the
switcher sends the tally signal to the correct camera. The camera number can be set to a value
of 1-99 by tapping the left or right buttons. The default setting is 1.
Color Bars
Outputting color bars rather than a preview image can be useful when connecting your
URSAMini to a switcher or external monitor. The appearance of your URSA Mini’s color bars
onyour switcher or monitor confirms the connection, and you can perform basic
monitorcalibration based on the colors of the bars. To turn on color bars for all outputs on
yourURSAMini, including the LCD touchscreen, simply tap the ‘color bars’ switch icon.
Program Audio
This setting is only available for URSA Mini Pro 4.6K. When connected to a switcher, setting
'program audio' to 'on' prioritizes the program return audio as your input source to be mixed
with talkback when monitoring using headphones or a headset. This is useful when you are not
feeding the switcher audio from your camera but you still want to listen to the program feed
from the mixer. Simply tap the 'program audio' switch icon to toggle camera audio or
program audio.
Headset Mic
Move this volume slider left or right to increase or decrease audio microphone input levels.
Thedefault setting is 50%.
Program Mix
This setting changes the balance of camera sound to talkback sound. The headphones will
output audio following what is displayed on the LCD. For instance, if you are in camera view,
camera audio is heard. If you are in program view, program audio is heard. The default
setting is 100%.
Reference Source
This setting is used to select the reference source. Your URSA Mini can lock to an internal or
external reference source, or to the reference signal in program input from an ATEM switcher.
Ifyou are using your URSA Mini with an ATEM Switcher’s camera control function, you should
always set your reference source to ‘program’ unless the switcher itself and all connected
cameras are set to an external reference.
Reference Timing
These settings allow you to manually adjust the reference timing on a line or pixel basis. Simply
tap the arrow icons on either side of the 'lines' and 'pixels' settings to make adjustments.
NOTE When you are setting your reference source for URSA Mini, you may experience
a small dropout on your camera’s outputs when switching between your reference
sources. This is because the camera is adjusting its referencing timing to match that of
the external source. For this reason it is important not to change this setting during a
production and only while setting up.
111Settings
To Next Page
Loading...
