Access Easy Controller APPENDIX A RJ45 Cable Assembly Procedure | en 187
Bosch Security Systems Hardware Manual Ver 2.0.0 | 2006.07
3. Step 3
a. Squeeze handles until die bottoms.
b. Depress locking tab (if applicable) and remove terminated modular plug cable
assembly.
When the crimping is completed, do a visual inspection through the plastic housing of the ter-
minated modular plug cable assembly. It should reveal whether the conductors are within
acceptable range.
The figure on the following page shows a cutaway of a typical terminated plug and the
required location of the conductors.
To Next Page
Loading...
