Access Easy Controller How to Install Reader and Field Devices | en 37
Bosch Security Systems Hardware Manual Ver 2.0.0 | 2006.07
6.2 HID ProxPoint Reader
1. Connect the terminal strip where the cable from the reader is terminated to the proper
connector on the 4-reader board.
Result: The reader LED will alternately flash between red & green for a few seconds.
Then the LED will remain lit in red.
2. Present a card to the reader.
Result: The LED should light in green briefly indicating that the reader recognized the
card.
X If the card is configured to allow access through the reader, then the door strike relay on
the reader card will activate and the red door strike LED on the same card will light indi-
cating that access has been granted.
3. Depending on the setup of the controller database for the card used in the previous step,
one of two events will occur within a second of the beep in step 2. Note that either
response indicates that the reader is working.
X If the card is configured to allow access through the reader, then the LED will light in
green for a few seconds indicating that access has been granted.
X Or, if the database has not yet been configured, then the LED will flash between red &
green in a rapid alternating pattern for two of three seconds indicating that access has
been denied.
To Next Page
Loading...
Need help?
General
