Access Easy Controller Table of Contents | en 3
Bosch Security Systems Hardware Manual Ver 2.0.0 | 2006.07
Table of Contents
1 Before You Begin 7
2 Overview of Access Easy Controller™ 8
2.1 Basic Access Easy Controller Configuration 9
3 System Layout 11
3.1 Single controller System 12
3.2 Two Controller Systems 13
3.3 Three Controller Systems 14
3.4 Controller Specifications 15
4 Is Access Easy Controller the Correct Choice for Your Client? 17
4.1 Checklist for Evaluating a Potential Access Easy Controller Application 17
4.2 When the network does not meet the requirements of Access Easy Controller 19
5 How to Install the Access Easy Controller 23
5.1 Preliminary 23
5.2 Controller Installation 24
6 How to Install Reader and Field Devices 31
6.1 HID MiniProx Reader 35
6.2 HID ProxPoint Reader 37
6.3 HID ProxPro Reader 39
6.4 HID ProxPro Reader with Keypad 41
6.5 S-Series Card Reader 43
6.6 S-Series Fingerprint Card Reader 45
6.7 Field devices using I/O board 46
6.7.1 Wiring Diagram for 2 State Supervised Input points 46
6.7.2 Wiring Diagram for 2 State Non-Supervised Input points 47
6.7.3 Wiring Diagram for 4 State Supervised Input points 48
6.8 Entry and Arm/Disarm Reader 49
6.8.1 Wiring diagram of a HID Compliant Entry and Arm/Disarm Reader 50
6.8.2 Wiring Diagram of a S-Series Entry and Arm/Disarm Reader 51
7 Common Alarm Output 52
7.1 Overview 52
7.2 Alarm (All Input Points) 52
7.3 Door Forced Opened and Door Held Opened 52
7.4 Panel AC Failure 53
7.5 Controller Tamper 53
7.6 Duress 53
8 How to Set Up the Access Easy Controller and the Computer 55
8.1 Overview 55
To Next Page
Loading...
Need help?
General
