Access Easy Controller
Configuring a Web Browser to Work with Access Easy
Controller | en 83
Bosch Security Systems Hardware Manual Ver 2.0.0 | 2006.07
11. Enter the Access Easy Controller's IP address in the browser's Address box as shown.
12. Press the Enter key or click . This should open the Access Easy Controller's login
page.
13. Proceed to login using the default user id: USER1 and password 8088. Upon successful
login, the controller's shown page will be displayed.
14. From the home page select the Panel Admin, Panel Setup. The Network Settings page
should be displayed. Make any needed changes to configure the controller for operation
on the customer's network. Click Save to store the changes.
15. After the database has been saved, reboot the controller. It will now boot using the new
IP address. The controller is now ready to be connected to the customer's network.
i
NOTICE!
For detailed information on database configuration, refer to the Access Easy Controller Soft-
ware User Manual.
To Next Page
Loading...
Need help?
General
