130 en | Points D9412GV4/D7412GV4/D7212GV4
F.01U.218.312 | 04 | 2012.03 Program Entry Guide Bosch Security Systems, Inc.
5 Points
5.1 Point Index
Use the point indexes to construct personality types for points used in the system. The Index
numbers are used in Point Assignments. Each unique point index number determines the
control panel’s responses to specific conditions occurring on the Protective points.
The D9412GV4/D7412GV4/D7212GV4 Program Record Sheet (P/N: F01U214958) and RPS
contain the default settings and descriptions for point indexes.
P## Type
Default Refer to the program record sheet
Section 0 to 9, or 11
P## Type Description
0 24-hour: A 24-hour point is not turned on and off from a keypad. 24-hour points are armed all the time,
and can be used for fire protection (refer to Section P## Fire Point, page 143), panic, medical, and
police alerts.
24-hour protection for fire doors, roof hatches, and so on. Instead of programming this type of
protection as a 24-hour point, consider using a Perimeter point type with a Point Response of 9 to E. 24-
hour points do not show faults when an arming function is entered, but Perimeter points do. When
programming this type of protection, consider also using the Buzz on Fault and Local While Disarmed
options.
1 Perimeter: Perimeter points are armed with all arming functions. Points programmed as perimeter can
also be armed as a group (using Perimeter-Arming functions) separately from points programmed as
interior. This lets the user partially arm the system to establish Perimeter protection while occupying
the interior of the protected premises.
Perimeter points can be programmed to activate entry delay time. If the point activates entry delay, it
can also activate an entry tone.
When a Perimeter point is programmed for entry delay, entry delay time is always provided. If the area is
in entry delay when a second Perimeter point is faulted, the control panel compares the remaining entry
delay time to the time programmed for the second Perimeter point. If the second Perimeter point’s
entry delay time is less than the remaining time, it shortens the entry delay time.
Perimeter points programmed for an instant point response, generate an alarm immediately when
faulted, even during entry or exit delay.
2 Interior: Interior points are armed only by master arming the area. They are not armed when using
Perimeter Arming functions. These points are typically used to monitor interior detection devices such
as interior doors, motion detectors, photoelectric beams, and carpet mats.
Instant Interior Points: Interior points are usually programmed for an instant alarm (refer to
Section 5.2 Point Responses, page 132). Points programmed for instant alarms generate alarms
immediately, even during entry or exit delay.
Delayed Interior Points: Interior points can be programmed for a delayed point response. A delayed
response means that if the point is faulted while the area is armed, it activates entry delay. It does not
generate an alarm until entry delay expires.
When an Interior point is programmed for entry delay, entry delay time is always provided. If the area is
in entry delay when a fault occurs for the Interior point, the control panel compares the remaining entry
delay time to the time programmed for the Interior point. If the Interior point’s entry delay time is less
than the remaining time, it shortens the entry delay time.
Delayed points can also activate an entry tone at the keypad (refer to the P## Entry Tone Off
prompt in
Section 5.2 Point Responses, page 132).
In some cases, you might need to create an Interior point that causes an instant alarm if the entry delay
is not started first. Use Interior Follower to create this type of protection.
To Next Page
Loading...
