D9412GV4/D7412GV4/D7212GV4 Panel and Area Wide Parameters | en 21
Bosch Security Systems, Inc. Program Entry Guide F.01U.218.312 | 04 | 2012.03
Table 3.2 ModemIIIa2 Communication Format Data - Point Numbers
3.2.1 Special Point/User Reporting
Independent Zone Control Notice: When using Independent Zone Controls (IZC) to send
Opening/Closing Reports by point, do not duplicate reporting independent point numbers
with User ID Reports (Section 4.1 Passcode or Token Worksheet, page 125). For example: If an
IZC is connected to Point 8, do not use User ID 8.
D6000: Opening/Closing User ID numbers are identified at the receiver as zones (same
identification as independent points). Refer to Table 3.3, Page 21.
Table 3.3 D6000 User IDs and Zones
DTMF Dialing
Use dual-tone multi-frequency (DTMF) to dial the central station receiver phone number(s) for
event reports, or to dial the remote programming software (RPS).
Point/User Flag NO Point/User Flag Yes
001 to 008 100 to 800
009 to 024 101 to 116
025 to 040 201 to 216
041 to 056 301 to 316
057 to 072 401 to 416
073 to 088 501 to 516
089 to 104 601 to 616
105 to 120 701 to 716
121 to 136 801 to 816
153 to 168 217 to 232
169 to 184 317 to 332
185 to 200 417 to 432
201 to 216 517 to 532
217 to 232 617 to 632
233 to 247 717 to 731
User ID Number Zone User ID Number Zone
1B911
2C922
3D933
4E044
5F955
66960
77
88
Default: Yes
Selection: Yes or No
Yes Dials the programmed phone number(s) using DTMF.
No Pulse dialing only.
To Next Page
Loading...
