EasyManua.ls Logo

Bosch D7412GV4 - Auxparm; Automation

Bosch D7412GV4
210 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
174 en | AUXPARM D9412GV4/D7412GV4/D7212GV4
F.01U.218.312 | 04 | 2012.03 Program Entry Guide Bosch Security Systems, Inc.
7 AUXPARM
7.1 Automation
Automation defines the characteristics of a serial interface module (SIM) when used with
home or business automation software. The SIM is a two-way SDI to a serial communication
module that allows the control panels to send and receive information to and from an external
software program.
This automation protocol allows external software programs to interact and perform functions
such as:
arming and disarming areas,
changing user passcodes and names, and
turning relays on and off.
The items described in this section allow some simple configuration options. To receive the
SIM automation protocol; however, you must contact Bosch Security Systems, Inc. Technical
Support at (888) 886-6189.
Supervise SDI 80
This item determines whether the serial interface module (SIM) at address 80 is supervised or
not. If the SIM is supervised, disconnecting the SIM from the control panel creates a Trouble
SDI 80 Event and the keypad annunciates a trouble tone (if programmed) and displays SERVC
SDI 80.
Automation Device
NOTICE!
The SIM can be a D9133, DX4010V2, or DX4020 (configured to emulate serial
communication).
A DX4010i can be used only for programming.
Default No
Selection: Yes or No
Yes Supervise the serial interface module (SIM).
No Do not supervise the serial interface module (SIM).
NOTICE!
Trouble SDI 80 Reports are always sent using the account number for Area 1.
Default None
Selection: SDI Address 80, SDI2 Address 1, SDI2 Address 2
None Disable Automation
SDI Address 80 Enables the automation address (SDI Address 80) for the DX4010V2 or
DX4010V2 Serial Interface Module, or DX4020 Network Interface
Module.
SDI2 Address 1 Enables automation and supervision using a B420 Ethernet
Communication Module at address 1 on the SDI2 bus.
SDI2 Address 2 Enables automation and supervision using a B420 Ethernet
Communication Module at address 2 on the SDI2 bus.

Table of Contents

Other manuals for Bosch D7412GV4

Related product manuals