D9412GV4/D7412GV4/D7212GV4 Points | en 151
Bosch Security Systems, Inc. Program Entry Guide F.01U.218.312 | 04 | 2012.03
Table 5.3 Cross Point Ranges Within Groups
Refer to Section 3.3 Routing, page 23 for information about programming the destination (for
example, the central station) for Unverified Events. An Unverified Event does not produce a
corresponding Restoral Event.
The Cross Point function applies only to alarm conditions. It does not apply to supervisory or
trouble conditions. Points programmed with point response D (Delayed) eventually enter into
an alarm condition if the area is not disarmed in time.
Cross Point Time
The Cross Point Time is the duration of the cross point window or the amount of time the
control panel waits for a second point within the same cross point group to fault before
generating an Cross Zone Alarm event. If a second point is not faulted within the Cross Point
Time, then a Burglar Alarm event is generated. Refer to Table 5.3, Page 151 for Cross Point
Group assignments.
5.5 COMMAND 7 and COMMAND 9
These entries assign point indexes, associated relays that activate, and the text for the
COMMAND 7 and COMMAND 9 keypad functions.
Cross Point Group Point Range
11to8
29to16
317to24
425to32
533to40
641to48
749to56
857to64
965to72
10 73 to 80
11 81 to 88
12 89 to 96
13 97 to 104
14 105 to 112
15 113 to 120
16 121 to 127
17 129 to 136
18 137 to 144
19 145 to 152
20 153 to 160
21 161 to 168
22 169 to 176
23 177 to 184
24 185 to 192
25 193 to 200
26 201 to 208
27 209 to 216
28 217 to 224
29 225 to 232
30 233 to 240
31 241 to 247
Default 20 sec
Selection: 5 sec to 255 sec
To Next Page
Loading...
